Energy and Exergy Analysis and Parametric Study of Gas Turbine Cycle Waste Heat Recovery in Different Configurations Using an ORC

Authors

Abstract

Since ordinary gas turbine cycles in actual condition comprise simple cycle, regenerative cycle, reheat cycle and intercooler cycle between high pressure and low pressure compressors, these cycles include 16 combined cycles by combining with a Rankine cycle that consists of three organic fluids and steam. In the present work, the thermodynamic analysis of the above combined cycles with three organic fluids and steam was considered in terms of the first and second laws of thermodynamics, and efficiency curves were compared together. The amount of exergy destruction and exergy efficiency of all cycles computed. Finally the effect of important parameters of the systems on the energy and exergy efficiencies has been shown. Results indicate that toluene fluid has the best efficiency regarding the first and the second law among all considered organic fluids. Results also show that, when the pressure ratio is more than 12, the efficiency of the first and second law of thermodynamics has the highest amount for the combination of reheat gas turbine cycle and Rankine cycle however, it has the lowest amount for the combination of simple gas turbine and Rankine cycle.

Keywords


[1] Chen, H., Goswami, D.Y., Rahman, M.M., Stefanakos, E.K., "A Supercritical Rankine Cycle Using Zeotropic Mixture Working Fluids for the Conversion of Low-Grade Heat into Power" .Energy, Vol. 36, pp. 549-555, 2011. [2] Chen, H., Goswami, D.Y., Rahman, M.M., Stefanakos, E.K., "Energetic and Exergetic Analysis of CO2- and R32-Based Transcriticalrankine Cycles for Low-Grade Heat Conversion", Applied Energy, Vol. 88, pp. 2802-2808, 2011. [3] Mikielewicz, D., Mikielewicz, J., "A Thermodynamic Criterion For Selection of Working Fluid for Subcritical and Supercritical Domestic Micro CHP", Applied Thermal Engineering, Vol. 30, pp. 2357-2362, 2010. [4] Rayegan, R., Tao, Y.X., "A Procedure to Select Working Fluids for Solar Organic Rankine Cycles (ORCs)", Renewable Energy. Vol. 36, pp. 659-670, 2011. [5] Shengjun, Z., Huaixin, W., Tao, G., "Performance Comparison and Parametric Optimization of Subcritical OrganicRankine Cycle (ORC) and transcritical power cycle System for Low-Temperature geothermal Power Generation", Applied Energy, Vol. 88, pp. 2740-2754, 2011. [6] Saleh, B., Koglbauer, G., Wendland, M., Fischer, J., "Working Fluids for Low-Temperature Organic Rankine cycles", Energy,Vol. 32, pp. 1210-1221, 2007. [7] Delgado-Torres, A.M., García-Rodríguez, L., "Analysis and Optimization of the Low-Temperature Solar Organic Rankine Cycle (ORC)", Energy Conversion and Management, Vol. 51, pp. 2846-2856, 2010. [8] Aljundi, I.H., "Effect of Dry Hydrocarbons and Critical Point Temperature on the Efficiencies of Organic Rankine Cycle", Renewable Energy, Vol. 36, pp. 1196-1202, 2011. [9] Chahartaghi, M., Babaei, M., "Energy and Exergy Analysis of Organic Rankine Cycle with Using Two-Component Working Fluid in Specified Heat Source Conditions", Modares Mechanical Engineering, Vol. 14, No. 3, pp. 145-156, 2014 (In Persian) [10]Yari, M., "Exergetic Analysis of Various Types of Geothermal Power Plants", Renewable Energy,Vol. 35, pp. 112-121, 2010. [11] Dai, Y., Wang, J., Gao, L., "Parametric Optimization and Comparative Study of Organic Rankine Cycle (ORC) for Low Grade Waste Heat Recovery", Energy Conversion and Management, Vol. 50, pp. 576-582, 2009. [12] Roy, J.P., Mishra, M.K., Misra, A., "Parametric Optimization and Performance Analysis of a Waste Heat Recovery System Using Organic Rankine Cycle", Energy, Vol. 35, pp. 5049-5062, 2010. [13] Tchanche, B.F., Papadakis, G., Lambrinos, G., Frangoudakis, A., "Fluid Selection for a Low-Temperature Solar Organic Rankine Cycle", Applied Thermal Engineering, Vol. 29, pp. 2468-2476, 2009. [14] Chacartegui, R., Sánchez, D., Muñoz, A., Sánchez,T., "Alternative ORC Bottoming Cycles for Combined Cycle Power Plants", Applied Energy,Vol. 86, pp. 2162-2170, 2009. [15] Kotas, TJ., "The Exergy Method of Thermal Plant Analysis". Great Britain: Anchor rendon Ltd., 1985. [16] Cengel, Y.A., Boles, M.A., Thermodynamics: an Engineering Approach, McGraw-Hill, New York, 5th ed.,2006. [17] Kenneth Wark, Jr., Advanced Thermodynamics for Engineers, Mc Grow-Hill, 2nd edition,1990. [18] Kanoglu, M.,Ayanoglu, A.," Exergoeconomic Assessment of a Geothermal Assisted High Temperature Steam Electrolysis System." ,Applied Energy,Vol. 36, pp. 4422-4433, 2011. [19] Baghernejad, A., Yaghoubi, M., "Exergoeconomic Analysis and Optimization of an Integrated Solar CombinedCycle System (ISCCS) using genetic algorithm", Applied Energy Conversion and Management, pp. 2193-2203, 2011.